Danger Den HD2900XT GPU Block
Ref: 465

Danger Den was contacted by ATI to help tame their new beast of a card. The first five Crossfire Sets flew out the door on there way to the 2007 Computex in Taipei!

Features:

• Pure Copper 110 used for the copper base
• High Flow design
• RAMSink has direct contact with watercooled base
• Easy installation with Hard Mount Stops built into the block.
• Compatible with HD2900XT and HD2900PRO
• Crossfire Compatible!

• Significantly reduces Load and Idle temperatures on the video card
• Capable of massive overclocks - card/silicon dependent
• Completely Anit-Corrosive. No Aluminum used
• Prepped for Crossfire
• See through Acrylic Top is back!
• All hardware is included to mount one block to one card...including thermal pads and Ceramique thermal paste.

• Includes the Danger Den warranty and support via Phone, Email, Forums, Live Chat, or Ticket system!!!
• Reduce temperature by more than 20C
• Bridges to cool all components are built in! No fumbling with bridge mounting hardware
• Allows the removal of the noisy fans on the Stock / OEM heatsink
• Uses the international standard G 1/4 BSPP Fittings
• Every block is pressure leak tested before shipment

• Fitting Size

• Instructions
• Reviews
• Sketchup Component (by Scooby @ The SCC)

Danger Den Tyee GPU Block (inc V-Reg Bridge) CF Prep'd **REDUCED**
Ref: 462

The Tyee is designed to provide maximum cooling for the ATI X1800 and X1900 series cards (Check the compatability list below)

New Features :

• Known compatible with the X1900 Standard (slave) and Master. X1800 Standard. Not compatible with AIW cards.
• Uses the Additional RAM Pad mounting points for maximum mounting contact
• Lower profile design to allow use of PCI slots on the top side of the block
• New hold down stainless steel design to allow the use of the PCI slot on the backside of the card.
• Modular design to allow cooling of the MASTER encoder chip and/or the Heat Bridge for the Voltage Regulators

Includes:

• Complete Block Assembled with Top and Gaskets
• Perfect Seal G 1/4 1/2" or 3/8" OD Fittings
• Just one Inlet and Outlet for complete cooling
• Low flow restriction low pressure drop
• Stainless Steel Hold Downs
• Hand Lapped
• Pressure tested before shipment
• Complete Block Assembled with Top, Gaskets, and Fittings. Ships with Hold Down Materials, Backing Plate, and Insulating Foam.
• Please leak test 24hrs upon receipt.
• Verify secure mount 48hrs after installation.

Options:

• Standard Version for single card cooling solutions.
• Prep for Crossfire - Adds additional plugged ports for later converions to Crossfire
• Heat Bridge - For cooling the voltage regulators
• Encoder Bridge - Required for cooling the Video Encoder chip on the MASTER Cards ONLY

Resources:

• Block Accessories
• Instructions
• Reviews

Danger Den Tyee V-Reg Bridge
Ref: 264

Voltage Regulator Bridge (included with single blocks, but NOT included with Crossfire Kits) for Tyee Series GPU Blocks

Danger Den X18 GPU Block (1/2") **CLEARANCE**
Ref: 723

New Features :

Includes: